Transcription of nRF52832 Development Kit v1.1
{{id}} {{{paragraph}}}
Example: barber
nRF52832 Development Kit v1.1
Doc. ID 4397_500 Development Kit ID 4397_500 2 ContentsRevision 1: 2: Setting up the Development 5 Chapter 3: Software 6 Chapter 4: Start 5: Interface IF Boot/Reset Virtual COM Dynamic Hardware Flow Control (HWFC) Interface MCU 6: Hardware Hardware Block Power Connector Buttons and I/O expander for buttons and kHz Measuring Preparing the Development kit Using an oscilloscope for current profile Using an ampere-meter for current RF Debug Debug NFC antenna Solder bridge ID 4397_500 3 Revision historyDateVersionDescriptionFebruary PDF for Development Kit (valid for all DK versions)Added MSD on page : Interface MCU firmware on page 9 Solder bridge configuration on page 27 Doc.
1. To set up the hardware, follow the instructions in Getting started with the nRF52 Development Kit. 2. To set up the software, follow the instructions in Nordic tools and downloads in nRF5 Getting Started. Actual software required depends on your OS and Development IDE.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: