Transcription of O2 Sensor Testing - ThunderMax
{{id}} {{{paragraph}}}
Example: air traffic controller
O2 Sensor Testing - ThunderMax
O2 Sensor Testing If your engine has unexpectedly started to run poorly, an O2 Sensor Test should be performed. IMPORTANT: Testing the O2 sensors using the procedures below REQUIRES that the engine will idle normally and with reasonable stability. This must be achieved by loading the original base map or a known good base map and clearing ALL learned conditions. After reloading the base map and clearing all learned conditions, if the engine does not idle reasonably well, the probability is VERY HIGH that there is a mechanical or electrical issue on the motorcycle causing the problem.
Initialization Test of O2 Sensors Throttle by Cable, SmartLink Software 1. Connect computer interface cable to the module. 2. Turn ignition switch ON.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Related search queries
Temperature Sensor Interface Module for, Temperature, NOx Sensor Kit User’s Manual, Sensor Module, Sensor, Module, Optical Proximity Sensor and Ambient Light, Optical Proximity Sensor and Ambient Light Sensor, A Low Cost Wireless Temperature, A Low Cost Wireless Temperature Monitoring, TECHNICAL DATASHEET #TDAXTC4 Thermocouple, TECHNICAL DATASHEET #TDAXTC4 Thermocouple Module, Ultralow Power Multi-sensor Data, 1000/2000/2400 & GEN4 ransmission April