Transcription of Operation Manual
{{id}} {{{paragraph}}}
Example: confidence
Operation Manual
WiringConnectionConnections should only be made with the powersupply turned separate routes for the pressure switch wiring andany power or high voltage wiring. Otherwise, malfunctionmay result due to that the FG terminal is connected to ground whenusing a commercially available switch -mode powersupply. When a switch -mode power supply is connected to the product,switching noise will be superimposed and the product specification can nolonger be met. This can be prevented by inserting a noise filter, such as aline noise filter and ferrite core, between the switch -mode power supply andthe product, or by using a series power supply instead of the switch -modepower ON and OFF point of the pressure (Hysteresis mode)When the pressure exceeds the set value, thePressure switch will turn the pressure falls below the setvalue by the amount of hysteresis ormore, the pressure switch will turn default setting of the output set valueis the central value between theatmospheric pressure and theupper limit of the rated pressurerange.
more, the Pressure switch will turn OFF. The d efault setting of the output set value is the central value between the atmospheric• pressure and the upper limit of the rated pressure range. If this condition, shown to the right, is acceptable, then keep these settings. Pressure Setting Digital Pressure Switch Operation Manual ZSE80(F)/ISE80(H)
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: