Transcription of Operation OManual
{{id}} {{{paragraph}}}
Example: tourism industry
Operation OManual
Pressure SettingSet ON and OFF point of the Pressure the pressure exceeds the set value, thePressure switch will turn the pressure falls below the set value bythe amount of hysteresis or more, thePressure switch will turn default setting of the output setvalue is the central value between theatmospheric pressure and the upperlimit of the rated pressure this condition, shown to theright, is acceptable, then keepthese settings.<How to operate>[Hysteresis mode]1. Press the button once in measurement [P_1] or [n_1] and the set value aredisplayed in / DisconnectingWhen mounting the connector, insert it straight into the socket, holding thelever and connector body, and push the connector until the lever hooks intothe housing, and removing the connector, press down the lever to release the hookfrom the housing and pull the connector straight Pressure SwitchOperation ManualZSE30A(F)/ISE30 AThank y
MPa ISE30A kPa ZSE30A(F) Measurement mode The measurement mode is the condition where the pressure is detected and indicated, and the switch function is operating. This is the basic mode, and the other modes should be selected for setting changes and other function settings.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: