Transcription of Operation OManual
{{id}} {{{paragraph}}}
Example: marketing
Operation OManual
Pressure SettingSet ON and OFF point of the Pressure the pressure exceeds the set value, thePressure switch will turn the pressure falls below the set value bythe amount of hysteresis or more, thePressure switch will turn default setting of the output setvalue is the central value between theatmospheric pressure and the upperlimit of the rated pressure this condition, shown to theright, is acceptable, then keepthese settings.<How to operate>[Hysteresis mode]1. Press the button once in measurement [P_1] or [n_1] and the set value aredisplayed in / DisconnectingWhen mounting the connector, insert it straight into the socket, holding thelever and connector body, and push the connector until the lever hooks intothe housing, and removing the connector, press down the lever to release the hookfrom the housing and pull the connector straight Pressure SwitchOperation ManualZSE30A(F)/ISE30 AThank you for purchasing an SMC ZSE30A(F)/ISE30A Series Digital read this manual carefully before operating the product and make sure youunderstand its capabilities and keep this manual handy for future obtain more detailed information about operating this product, pleaserefer to the SMC websit
The Pressure switch operates within a set pressure range (from P1L to P1H) during window comparator mode. Set P1L (switch lower limit) and P1H (switch upper limit) with the setting procedure above. (When reversed output is selected, [n1L] and [n1H] are displayed.) Z e roc lafdisp y The display is reset to zero when the and buttons are pressed
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: