Transcription of Outboard Motor Tachometer IS0012 - Faria Beede
{{id}} {{{paragraph}}}
Example: tourism industry
Outboard Motor Tachometer IS0012 - Faria Beede
Disconnect the battery during installation. Tighten nuts on the backclamp only slightly more than you can tighten with your fingers. Six inch-pounds of torque is sufficient. Overtightening may result in damage to the instrument and may void your Location: The Tachometer should be located at least 18 from a magnetic compass. Some interference (erratic operation) may be noticed on the Tachometer during radio transmissions. This will neither damage a Tachometer nor affect accuracy when not Be certain to use stranded, insulated wire not lighter than 18 AWG that is approved for marine use. It is recommended that insulated wire terminals, preferably ring type, be used on all connections to the tach, except the light, which requires a 1/4 insulated female blade terminal.
Overtightening may result in damage to the instrument and may void your warranty. 1. Location: The tachometer should be located at least 18” from a ... Rev. AC ecn 10592 6/2017 Caution Made in the USA Installation Wire Connections Reconnect Power ... Tohatsu / Nissan to Present 4 M40D, 40D2, 50D, 50D2, 70B
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: