Transcription of OWNER’S GUIDE & INSTALLATION INSTRUCTIONS
{{id}} {{{paragraph}}}
Example: stock market
OWNER’S GUIDE & INSTALLATION INSTRUCTIONS
17-335-01-irev. 1106/01/15 External-Mount, 2-3kWDepth Transducer with Temperature SensorModels: R99, R109LH, R109LM, R109 LHW, R209, R309, R409 LWM, R509LH, R509LM, Patent No. 7,369,45; 8,582,393. UK Patent No. 2 414 077 IMPORTANT: Please read the INSTRUCTIONS completely before proceeding with the INSTALLATION . These INSTRUCTIONS supersede any other INSTRUCTIONS in your instrument manual if they Recommended for all hull materials Not recommended for hulls less than 9 m (30') long Not recommended for stepped hulls. Mount an in-hull transducer Accommodates a deadrise angle up to 22 Unpacking & PretestRemove and discard the packing hardware (rod and 2 nuts) (see Figure 1). Connect the temperature function to the instrument and check for the approximate air temperature. If there is no reading or it is inaccurate, check the connections and test again. If there is still a problem, return the product to your place of & MaterialsSafety gogglesDust maskAngle finderBand saw (blade must be very sharp)Rasp or power toolElectric drillDrill bits:pilot hole3 mm or 1/8"fiberglass, wood, or steel hull14 mm or 9/16"aluminum hull15 mm or 9/16"Permanent markerMild household detergent or weak solvent (such as alcohol)SandpaperFile ( INSTALLATION in a metal hull)Marine sealant (suitable for below waterline)WrenchesTorque wrenchGrommet(s) (some installations)Cable tiesWater-based anti-fouling paint (mandatory in salt water)Record the information found on the cable t
2 Figure 5. Fairing Figure 6. Fairing NOTE: After the fairing is cut, the section with the cutting guide becomes the backing block. 20mm (3/4") cutting guide cavity for 22° max
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: