Transcription of Pipe
{{id}} {{{paragraph}}}
Example: bankruptcy
Pipe
AN AMERICAN NATIONAL STANDARDS tainless Steel PipeASME (Revision of ANSI/ASME )Copyright ASME International Provided by IHS under license with ASME Licensee=Defense Contract Mgmt Command/5935922100 Not for Resale, 06/04/2006 05:53:28 MDTNo reproduction or networking permitted without license from IHS--`,`,`,``,``,,`,`,`,,,,```,`,`-`-`,, `,,`,`,,` STEELPIPEASME (Revision of ANSI/ASME )Copyright ASME International Provided by IHS under license with ASME Licensee=Defense Contract Mgmt Command/5935922100 Not for Resale, 06/04/2006 05:53:28 MDTNo reproduction or networking permitted without license from IHS--`,`,`,``,``,,`,`,`,,,,```,`,`-`-`,, `,,`,`,,`---Date of Issuance: October 25, 2004 This Standard will be revised when the Society approves the issuance of a new edition. There willbe no addenda or written interpretations of the requirements of this Standard issued to this is the registered trademark of The American Society of Mechanical code or standard was developed under procedures accredited as meeting the criteria for American NationalStandards.
7 PIPE THREADS Unless otherwise specified, the threads of threaded pipe shall conform to ANSI/ASME B1.20.1, Pipe Threads, General Purpose (Inch). 1 The different grades of stainless steel have different specific densities and hence may weigh more or less than the values listed in Table 1 would indicate [see Table 1, General Note (e)].
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: