Transcription of PL-2303HXD Migration Guide - prolificusa.com
{{id}} {{{paragraph}}}
Example: barber
PL-2303HXD Migration Guide - prolificusa.com
PL-2303 HXD Migration Guide Document Rev PL-2303 HXD Migration Prolific Technology Inc. - 1 of 4 - July 9, 2012 All information herein is subject to change without prior notice. Prolific Technology Inc. does not make any warranties regarding the accuracy and completeness of this document and shall in no event be liable for any loss of profit or any other commercial damage, including but not limited to special, incidental, consequential, or other damages. PL-2303 HXD USB-to-Serial Bridge Controller Migration Guide Application Note Introduction This application note provides important Migration guidelines for PL-2303 HXD Edition USB-to-Serial Bridge Controller. Refer to this application note if you are migrating from PL-2303HX (Chip Rev A) or PL-2303X (Chip Rev A) to the PL-2303 HXD. PL-2303 HXA, XA and HXD Chip Comparison Table Following are the difference between PL-2303 HXA, PL-2303XA, and PL-2303 HXD chips: PL-2303X (Chip A) or PL-2303XA PL-2303HX (Chip A) or PL-2303 HXA PL-2303HX (Chip D) or pl2303 HXD Core Voltage RS-232 VDD ~ ~ ~ Baud Rate setting 75 ~ 6M bps 75 ~ 6M bps 75 ~ 12M bps Clock Source External 12 MHz crystal & Internal 4X PLL External 12 MHz crystal & Internal 4X PLL Internal 96 MHz clock generator Initial Startup Configuration External EEPROM External EEPROM Internal OTPROM Hardware Flow Control RTS/CTS RTS/CTS RTS/CTS or DTR/DSR General Purpose IO 2 (GP0/1) 2 (GP0/1)
Windows will detect the PL-2303HXD device and loads the pre-installed driver. Check ... Refer to the PL2303 EEPROM Writer User Manual. Contact Prolific FAE for support. PL-2303HXD Migration Guide Document Rev 1.6 PL-2303HXD Migration Guide_v1.6 Prolific Technology Inc. - 4 of 4 - July 9, 2012
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: