Transcription of PLC Lab Manual - infoPLC
{{id}} {{{paragraph}}}
Example: air traffic controller
PLC Lab Manual - infoPLC
Include CD-ROM PLC Lab Manual 2008-2009 Prepared By Eng. Wael Younis Lab Manual 2 Table Of Contents Experiment #1 Operating a simple loads using relays, switches and pushbuttons 3 Experiment #2 PLC Input Output Wiring Methods 6 Experiment #3 Programming the PLC Via Ladder logic 14 Experiment #4 Position control for satellite dish DC motors 26 Experiment #5 Starting Three Phase induction Motors Via Star-Delta Starter 30 Experiment #6 Programming PLC Via SFC 36 Lab Manual 3 Experiment #1 Operating a simple loads using relays, switches and pushbuttons OBJECTIVES After successfully completing this laboratory, you should be able to: Identify the basic components of the control board. Assemble and arrange a simple control board. Explain the operation of electromagnetically controlled circuits.
Single phase power source. (42x55)cm wooden board. Mounting rails. Wiring ducts (panel type) Terminals. 2. Procedure Part 1 1. Using the wooden board, wiring ducts and mounting rails, assemble and arrange the control board as shown in figure 1.1. 42 55 1,8 32,4 16,2 3 14 3 14 3 3 Fig. 1.1 The power circuit diagram for a direct on line starter
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: