Transcription of Pneumatic Rack & Pinion Actuator - FNW Valve
{{id}} {{{paragraph}}}
PneumaticRack & Pinion Actuator4120 NE Columbia Blvd. - Portland, Oregon USA 97211 Phone: 503-287-8383 - Fax: 503-281-9677 - Per Side1111-2-12/322-22--23/3312312-33/4421 42-244/4522522-54/5622265/575/686/6 Actuator BODYThe Actuator body is made from extruded aluminum and coated with a nickel plated exterior (standard) for increased corrosion resistance ( Actuator is also available in hard anodized aluminum).END CAPSEnd caps are die cast aluminum coatedwith corrosion resistant stainless steelimpregnated epoxy (anodized aluminummodels have poly-powder coat) and are secured with full length stainless steel and spring - return actuators utilize the same end caps allowing quick conversion by adding or removing springs as Pinion is ground from hardened steel then nickel plated for maximum corrosion and wear INDICATORLow profile position indicator also acts as the cam for the Actuator stopadjustments and still leaves room for mounting accessories.
Double-acting and spring-return actuators utilize the same end caps allowing quick conversion by adding or removing springs as needed. PINION The pinion is ground from hardened steel then nickel plated for maximum corrosion and wear resistance. POSITION INDICATOR Low profile position indicator also acts as the cam for the actuator stop
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}