Transcription of POLYETHYLENE FITTINGS - JM Eagle
{{id}} {{{paragraph}}}
Example: bankruptcy
POLYETHYLENE FITTINGS - JM Eagle
Building essentials for a better tomorrow MDPE & HDPE FITTINGS MEET ASTM D2513, D2683, D3261 METFIT FITTINGS MEET ASTM D2513, F1924 POLYETHYLENE FITTINGSPRICE LISTPRICE LISTPOLYETHYLENEFITTINGSMDPE & HDPE FITTINGS MEET ASTM D2513, D2683, D3261 MetFit FITTINGS MEET ASTM D2513, F1924 MATERIAL DESIGNATION CODES AND APPLICAbLE STANDARDSAll USPoly fusion FITTINGS are produced from a resin listed in PPI's (Plastic Pipe Institute) TR-4 listing of approved material designation code for MDPE UAC 2000 FITTINGS is PE 2406/PE 2708, with a recommended hydrostatic design basis (HDb) of 1250 PSI @ 73 degrees material designation code of HDPE FITTINGS is PE 3408/PE 3608/PE 4710, with a recommended hydrostatic design basis (HDb) of 1600 PSI @ 73 degrees Fahrenheit.
1¼" IPS butt fusion outlet high volume tapping tees. Protective sleeves are available. The last number of the Product Code is changed from a 1 to 5 when a protective sleeve is included. Add $2.90 each when sleeves are included. note:
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: