Transcription of Power Transformer Protection
{{id}} {{{paragraph}}}
A GO3-5005 EMarch 1988 Power Transformer ProtectionApplication GuideAuthorR NylenSenior application engineer)ABB RelaysPower Transformer protectionAGO3-5005 EPage 2 List of contents)1. INTRODUCTION2. CONDITlONS LEADING TO FAUL Insulation Aging of Overheating due to Oil contamination and Reduced cooling3. FAULT Ground faults in a solidly groundedstar-connected secondary Ground faults in a high impedancegrounded star-connectedsecondary Ground faults in a Turn-to-turn Phase-to-phase faults4. PROTECTIVE RELA Differential Differential relays for fully Differential relays for Overcurrent Protection andimpedance Time-overcurrent Under-impedance Distance Grou~d fault Low irrnpedance residualovercurrent Harmonic restraint High impedance restricted Low impedance restricted Tank Residual voltage Overexcitation Flashover and ground faultprotections for low voltage Systems without rectifiers orfrequency Systems with rectifiers andfrequency converters withoutpulse' Systems with rectifiers and pulse - width - modulated frequencyconverters5.
pulse'width-modulation 4.6.3 Systems with rectifiers and pulse-width-modulated frequency converters 5. MONITORS 5.1 Gener,al 5.2 Gas d~tector relay 5.3 Temperature monitoring 5.4 PresslUre relay for on-load tap-changsrs 5.5 PresslUre relief valve 5.6 Oil level monitor 5.7 Silica gel dehydrating breather ...
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}