Transcription of Power Trim and Tilt Systems
{{id}} {{{paragraph}}}
Chapter EighteenPower trim and tilt SystemsThe MerCruiser Power trim system permitsraising or lowering the stern drive unit for efficientoperation under varying conditions. Early sterndrive units used a mechanical tilt system in theform of a series of holes in the gimbal ring. Afterthe unit was set at the desired angle, an adjustmentstud inserted through the appropriate hole held itin chapter covers three MerCruiser Power trimand tilt Systems : the high-pressure pump system ,low-pressure pump system and auto trim PUMP SYSTEMThis MerCruiser Power trim and tilt system electricalsub- system consists of a Power trim control panelor handle, a pump motor and a trim limit switch,with connecting wir
POWER TRIM AND TILT SYSTEMS 535 Trim Limit/Trim Position Sender Switches The trim limit (TL) switch is located on the left side of the gimbal housing. This switch permits only a limited amount of outward trim travel to provide safe control at high speeds and prevent damage to drive unit or trim cylinder due to lost side support of drive unit.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}