Transcription of Power Trim and Tilt Systems
{{id}} {{{paragraph}}}
Example: tourism industry
Power Trim and Tilt Systems
Chapter EighteenPower Trim and Tilt SystemsThe MerCruiser Power trim system permitsraising or lowering the stern drive unit for efficientoperation under varying conditions. Early sterndrive units used a mechanical tilt system in theform of a series of holes in the gimbal ring. Afterthe unit was set at the desired angle, an adjustmentstud inserted through the appropriate hole held itin chapter covers three MerCruiser Power trimand tilt Systems : the high-pressure pump system,low-pressure pump system and auto trim PUMP SYSTEMThis MerCruiser Power trim and tilt system electricalsub-system consists of a Power trim control panelor handle, a pump motor and a trim limit switch,with connecting wiring.
power supply side of ignition switch 4. Connect to “1” terminal on an adjacent gauge or to any switched 12 volt terminal. r-Relay No. 1 test Diode pack test 1. Connect a voltmeter between terminals 2 and 4. If voltmeter scale shows no reading, replace the relay. 2. Connect a jumper lead between terminals 3 and 5. 3. Repeat Step 1.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: