Transcription of PRO3000™ Toner and Probe Users Guide …
{{id}} {{{paragraph}}}
Example: confidence
PRO3000™ Toner and Probe Users Guide …
PN 2636321, April 2006, Rev. 1 10/08. 2006, 2008 Fluke Corporation. All rights in China. All product names are trademarks of their respective Toner and Probe Users GuidePRO3000 G n rateur de tonalit et sonde Guide de l UtilisateurPRO3000 Generador de tono y sonda Gu a de UsoPRO3000 Toner and Probe Users GuideIntroductionThe PRO3000 Toner and PRO3000 Probe helps you identify cables, wires, and wire pairs. You connect the PRO3000 Toner to a line, then trace and follow the signal with the PRO3000 InformationThe following IEC symbols are used either on the test set or in the manual :WXWarningThis product is certified for indoor use avoid electrical shock, do not use the Toner or Probe if they are wet. If they get wet, let them dry for 24 hours before connecting to metallic network wires, handle alligator clips by the insulated maximum voltage allowed across the test leads is 60 Vdc in Toner and polarity modes.
The following IEC symbols are used either on the test set or in the manual: WX Warning This product is certified for indoor use only. To avoid electrical shock, do not use the toner or probe if they are wet. If they get wet, let them dry for 24 hours before use. When connecting to metallic network wires, handle alligator clips by the insulated boot. The …
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: