Transcription of PROGRAMMABLE CONTROL - Workrite Ergonomics
{{id}} {{{paragraph}}}
Example: bachelor of science
PROGRAMMABLE CONTROL - Workrite Ergonomics
PROGRAMMABLE CONTROLUser TIME WORKCENTER OPERATIONIf your workcenter has not been Initialized the code E0 1 appears when you press any of the CONTROL YOUR WORKCENTER1. Press and hold button until the workcenter moves all the way down and the display reads " then release the Press and hold button AGAIN until the workcenter moves down then up slightly. Your Sierra SEHX or Fundamentals FDEX workcenters are now ready to use. For Sierra HXL the readout needs to be changed to read " using the Adjusting Display Height step THE DISPLAY HEIGHT FOR SIERRA HXL1. Press button to fully lower the workcenter and the display reads ".
MEMORY BUTTON FACTORY SETTINGS The Programmable Switch is pre-programmed from the factory at the following heights: Button 1 preset at 26" – Seated work surface height for the average female.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: