Transcription of PROGRAMMING AND INSTALLATION GUIDE - DMP.com
{{id}} {{{paragraph}}}
DualCom Series Universal Alarm CommunicatorDigital Monitoring Products, Inc. 2022 PROGRAMMING AND INSTALLATION GUIDETABLE OF CONTENTSA bout the Communicator ..1 System Components .. (PROG) Connection .. Button ..2 Load Button ..2 Backlit Logo ..3 ECP and DSC Passthru ..3 INSTALLATION ..4 Select a Location ..4 Mount the Communicator ..4 Wire the Communicator ..5 Connect the Antenna ..5 Applications ..6 CID Dialer Connection ..6 Communication Failure (DualComNF only) ..6 Zones 1 4 Input Connection ..6 Zone 4 Bell Connection ..7 ECP Passthru Connection ..9 DSC Passthru Connection ..11 Arming and Disarming ..12 Use the Virtual Keypad App ..12 Use Outputs ..12 Activate the Cellular Module ..14 Dealer Admin Activation ..14 Tech APP Activation ..14 Remote Link Activation ..14 PROGRAMMING ..15 Before You Begin ..15 Getting Started ..15 PROGRAMMING Menu ..15 Reset Timeout ..16 Special Keys.
8. When the green LED on the Model 401 starts a slow flash, release the load button. The slow flash will last 5 minutes, then the green LED will become steady, indicating the firmware version is updated. Note: If the LED blinks rapidly, the update was unsuccessful. Press and release RESET.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}