Transcription of Project Standards and Specifications Inspection of Pumps
{{id}} {{{paragraph}}}
Page : 1 of 21. KLM Technology Group Rev: 01. Project Engineering April 2012. Standard KLM Technology Group #03-12 Block Aronia, Specifications FOR PUMP Inspection . Jalan Sri Perkasa 2. Taman Tampoi Utama 81200 Johor Bahru ( Project Standards AND Specifications ). Malaysia TABLE OF CONTENT. SCOPE 2. REFERENCES 2. DEFINITIONS AND TERMINOLOGY 2. GENERAL 2. INTRODUCTION 2. PREDICTIVE MAINTENANCE SCHEDULE FOR CENTRIFUGAL Pumps 3. PREVENTIVE MAINTENANCE Inspection SCHEDULE FOR. CENTRIFUGAL Pumps 3. Horizontal Centrifugal Pumps (Both ends supported) 3. Horizontal Centrifugal Pumps (Overhanging Type) 5. Submersible Pumps (Wet Motor Type & Dry Motor Type) 6. Vertical Centrifugal Pumps 7. Partwise Inspection during complete Overhaul of Centrifugal Pumps 8. Commissioning and Testing Procedures for Centrifugal Pumps 12.
Positive Displacement Pumps (Reciprocating Pumps, Gear Pumps, Screw Pumps and Dosing Pumps). REFERENCES Throughout this Standard, the following dated and undated standards and codes are referred to. These referenced documents shall, to the extent specified herein
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}