Transcription of PVC Pipe—Design and Installation - American Water Works ...
{{id}} {{{paragraph}}}
PVC Pipe Design and InstallationAWWA MANUAL M23 Second EditionScience and TechnologyAWWA unites the drinking Water community by developing and distributing authoritative scientific and technological knowledge. Through its members, AWWA develops industry standards for products and processes that advance public health and safety. AWWA also provides quality improvement programs for Water and wastewater 2002 American Water Works Association, All Rights ReservedContentsiiiList of Figures, vList of Tables, viiForeword, ixAcknowledgments, xiChapter 1 General Properties of Polyvinyl Chloride , 1 Material Properties of PVC Pipe Compounds, 1 Corrosion, Permeation, and Chemical Resistance, 2 Environmental Effects, 5 Chapter 2 Testing and and Inspection, 9 Chapter 3 Formulas, 13 Chapter 4 Design Factors Related to External Forces and Loads, 21 Flexible Pipe Theory, 24 Longitudinal Bending, 33 Expansion and Contraction, 40 Thrust Restraint General, 42 Chapter 5 Pressure Hydrostatic Pressure, 53 Distribution Mains, 58 Transmission Mains, 59 Injection-Molded PVC Fittings, 62 Fabricated PVC Fittings, 63 Dynamic Surge Pressure.
PVC compound with cell classification 12454-B or better. Those compounds must also qualify for a hydrostatic design basis of 4,000 psi (27.58 MPa) for water at 73.4°F (23°C) per the requirements of PPI † TR-3. The manner in which selected materials are identified by this classification sys-
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}