Transcription of PYROMETER AND THERMOCOUPLE INSTALLATION …
{{id}} {{{paragraph}}}
Example: tourism industry
PYROMETER AND THERMOCOUPLE INSTALLATION …
Form No. IS171 (Rev. H 09/10/2014) ISSPRO, INC. 2515 Riverside Way Post Office Box 11177 Portland, Oregon 97211-1899 503-528-3400 800-888-8065 Fax: 503-528-3495 2008 ISSPRO, Inc. All Rights Reserved. PYROMETER AND THERMOCOUPLE INSTALLATION INSTRUCTIONS I C O N K E Y CAUTION Tools may be required Shown in picture 1 Disconnect batteries. Do not reconnect battery power until system is fully configured to avoid risk of shock or fire. 2 Install THERMOCOUPLE . The THERMOCOUPLE mounts into a pipe thread. If the exhaust manifold is already drilled and tapped, the THERMOCOUPLE can be installed at the location. If none is provided, drill (with letter R bit) and tap the hole using NPT tap. Apply a small amount of anti seize lubricant to the exposed threads of the fitting and tighten using the hex (wrench flats) which are closer to the tip of the THERMOCOUPLE . Adjust the depth of the probe (tip of the probe should be approximately at the center of the exhaust flow), and tighten the outermost nut no more than one half turn past finger tight.
Form No. IS171 (Rev. H 09/10/2014) ISSPRO, INC. • 2515 N.E. Riverside Way • Post Office Box 11177 • Portland, Oregon 97211-1899 503-528-3400 • 800-888-8065 ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: