Transcription of Quick Start Guide - Balluff
{{id}} {{{paragraph}}}
Example: stock market
Quick Start Guide - Balluff
Distributed Modular I/O Quick Start Guide for 4 port IO-Link Master CommunicationDiscrete I/ODiscrete I/OAnalog I/OOutputsSpecialtyPowerPowerDiscreteI/O AnalogI/OValve ManifoldControlRFID or Specialty DevicesDiscreteI/OQuick Start GuideBNI004 ABNI EIP-502-105-Z0152 Connect the Distributed Modular I/O Master Block11. Using an M12 D-coded EtherNet/IP cable, connect the block to the Ethernet network. 2. Power up the block using 24 VDC and a 7/8" 4pole connector wired according to the below diagram. 3. Set the IP address of the block using the pushbutton display. For instructions on operating the display, see the 0 Port 1 Port 2 Port 3 Port 4 Port 5 Port 6 Port 7IO-Link 1IO-Link 2IO-Link 3IO-Link 4 PinFunctionDescription1TX +Transmit Data +2RX +Receive Data +3TX -Transmit Data -4RX -Receive Data -M12 Network PortPinFunctionDescription1+ 24 VActuator Supply2+ 24 VSensor/Bus Communication Supply30 V Sensor/Bus Communication Supply40 VActuator Supply7/8" Auxiliary Power PortPinConfigurable PortIO-Link Port1+ 24 V+ 24 V2 Input 2 or Output 2 Input/Output 230 V0 V4 Input 1 or Output 1IO-Link or Input/Output 15 FEFEM1
Quick Start Guide BNI004A BNI EIP-502-105-Z015. 2 Connect the Distributed Modular I/O Master Block 1 1. Using an M12 D-coded EtherNet/IP cable, connect the block to the Ethernet network. 2. Power up the block using 24VDC and a 7/8" 4pole connector wired according to …
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: