Transcription of Revision Foundation Specifications - vincor.com
{{id}} {{{paragraph}}}
Installation InstructionsBulletin 37690 BFoundation Specificationsfor Type ES45T-T and Earth Station AntennasRevision document specifies typical Foundation characteris-tics, designs, requirements and dimensional specificationsfor the Andrew Earth Station Foundation LOADING loads are applied to the three foundationpads as shown in Figure 1. Positive applied forces are inthe direction of the X, Y. and Z coordinate load conditions are dependent upon icing, inci-dent angle of the wind and elevation/azimuth angles of theantenna. Foundation loading for various icing,elevation/azimuth and wind conditions are listed in Table 1 PAD 3 PAD 2 YXZF igure 1 Andrew Corporation10500 West 153rd StreetOrland Park, IL 60462 Telephone: 708-349-3300 FAX ( ): 1-800-349-5444 Internet: Service, 24 hours: Canada Mexico: : 0800 250055 Republic of Ireland: 1 800 535358 Other Europe: +44 1592 782612 Printed in 3/05 Copyright 2005 by Andrew ANCHOR BOLT anchor bolt installation configurations and di-mensions are shown in Figure Type 47429A Anchor Bolt Kit includes anchorbolts, alignment plates and required mounting hardware asshown in Figures 3 and Foundation selected Foundation for a particular site is depen-dent upon local conditions.
General Notes - Figure 3 6 Foundation Notes: 1. Contractor shall verify all dimensions before execution of work. 2. All concrete used in the work shall be 3000 PSI (20685
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}