Transcription of Rout Tolerance - PCB-POOL
{{id}} {{{paragraph}}}
Example: tourism industry
Rout Tolerance - PCB-POOL
Rout ToleranceDesign rules:Almost any shape can be created by routing, however a few basic rules must be observed: - PCB-POOL uses two types of routing bits: mm and mm. - All copper structures on the board must be mm clear of the routing contour. - Plated drills on the edge of the PCB, which will be bisected by the contour line, must have a minimum diameter of mm and have a remaining radius of mm after routing ( )- Outer contours can shape any angle while inner contours will produce at least the radius of the routing bit. - Production Tolerance is +/- mm CM - SO - 003 / D / 2011 Routing BitRadius mmFig.
Rout Tolerance Design rules: Almost any shape can be created by routing, however a few basic rules must be observed: - PCB-Pool® …
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: