Transcription of Section 2. Oscillator - Microchip Technology
{{id}} {{{paragraph}}}
1997 Microchip Technology Inc. DS31002A page 2-1 M Oscillator 2 Section 2. Oscillator HIGHLIGHTS This Section of the manual contains the following major .. Configurations .. oscillators / Ceramic Resonators .. RC 4 MHz RC Oscillator .. of Sleep Mode on the On-chip Oscillator .. of Device Reset on the On-chip Oscillator .. Tips .. Application Revision History ..2-20 PICmicro MID-RANGE MCU FAMILY DS31002A-page 2-2 1997 Microchip Technology Inc. Introduction The internal Oscillator circuit is used to generate the device clock. The device clock is requiredfor the device to execute instructions and for the peripherals to function. Four device clock peri-ods generate one internal instruction clock (T CY ) cycle. There are up to eight different modes which the Oscillator may have. There are two modes whichallow the selection of the internal RC Oscillator clock out (CLKOUT) to be driven on an I/O pin, orallow that I/O pin to be used for a general purpose function.
1997 Microchip Technology Inc. DS31002A page 2-1 M Oscillator 2 Section 2. Oscillator HIGHLIGHTS This section of the manual contains the following major topics:
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}
Oscillator Application Notes - Frequency, FREQUENCY, NOTES, Application, Primary-Side Push-Pull Oscillator with Dead-Time, PRIMARY-SIDE PUSH-PULL OSCILLATOR WITH DEAD-TIME CONTROL www.ti.com, Oscillator, Crystal Oscillator, Quartz Crystal Oscillator, Recommendations for Control of Radiated, Xilinx XAPP1113 Designing Efficient Digital Up and