Transcription of SensaGuard Rectangular Flat Pack Installation Instructions
{{id}} {{{paragraph}}}
Example: dental hygienist
SensaGuard Rectangular Flat Pack Installation Instructions
Installation InstructionsOriginal InstructionsSensaGuard Rectangular Flat Pack(Series B Models Only)Catalog Number 440N-Z21xSummary of ChangesThis publication contains a new Assured ON sensing distance for -CU models (see page 2).IntroductionInstallation must be in accordance with the following Instructions and specifications and implemented by suitable competent personnel. Adherence to the recommended maintenance Instructions forms part of the unit is not to be used as a mechanical stop. Guard stops and guides must be device is intended to be part of the safety-related control system of a machine. Before Installation , a risk assessment is performed to determine whether the specifications of this device are suitable for all foreseeable operational and environmental THESE Instructions FOR FUTURE p i c P a g eSummary of Changes1 Introduction1 Specifications2 Dimensions2 Mode of Operation Status I
414-3 of IEC 60364-4-41 where provisions have been taken. To confirm that, even if an internal fault, the voltage at the outgoing terminals cannot exceed 60V DC. Improper selection or installation of the devices affects the integrity of the safety systems.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: