Transcription of Series 1 Steel - Accessories - Cooper Industries
{{id}} {{{paragraph}}}
Example: air traffic controller
Series 1 Steel - Accessories - Cooper Industries
Series 1 Steel - Accessories Covers Solid covers should be used when maximum enclosure of the cables is desired and no accumulation of heat is expected. Ventilated covers provide an overhead cable shield yet allow heat to escape. We recommend that covers on vertical cable tray runs to a height of 6 ft. ( m) to 8 ft. ( m) above the floor to isolate both cables and personnel. Flanged covers have a .30 in. ( mm) flange. Cover clamps are not included with the cover and must be ordered separately. Solid Non-Flanged Solid Flanged Ventilated Flanged Covers Part Numbering Prefix Example: 80 1 P - 24 - 144. Cover Type Detail Material Tray Width Item Description 80 = Solid 1 = Flanged P = Pre-Galvanized 06 = 6" For Straight Section Cover: 81 = Ventilated 9 = Non-Flanged G = HDGAF 09 = 9" Pre-Galvanized Only: 12 = 12" 144 = 12 ft. ( m). 18 = 18" 120 = 10 ft. ( m). 24 = 24" Pre-Galvanized & HDGAF. 30 = 30" 72 = 6 ft. ( m). 36 = 36" 60 = 5 ft. ( m). For fitting covers: Insert suffix of fitting to be covered.
Series 1 Steel Series 1 Steel - Accessories B-Line series Cable Tray Systems H-16 Eaton Tray Catalog No. Series Znplt HDGAF 148 9ZN-9019 9G-9019 156 9ZN-9014 9G-9014 166 9ZN-9015 9G-9015 176 9ZN-9016 9G-9016 † Specify gap of 1", 2", 3" or 4".
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: