Transcription of Series with RedLINK Installation Guide
{{id}} {{{paragraph}}}
Example: confidence
Series with RedLINK Installation Guide
VisionPRO Series with RedLINK Installation GuideTMTMORORW ired Directly to Equipment2 Wires for Power orBattery Only (no wires)2 Wires for Power orBattery Only (no wires)Dual Powered - C Wire or Battery(C wire or Wire Saver required to use RedLINK accessories) RedLINK to Equipment Interface ModuleRedLINK to TrueZONE Wireless AdapterTM 2 Current display. Underlined label signifies the current control buttons. Use to change settings for Fan or System Select options to: set schedules, view equipment status, change IAQ settings, access installer options*, status. Shows system mode (heat/cool), outdoor temperature and humidity (with optional outdoor sensor).Current schedule. Shows desired temperature and schedule conditions. Shows indoor temperature and Light. On when alert message is active or system is set to Em Heat. Flashes for battery-only power; on continuous for 24 Card Port.
Installation Guide TM TM OR OR Wired Directly to Equipmen t 2 Wires for P ower or Batter y Only (no wires) ... Follow these basic steps to install this thermostat, link it with the wireless accessories, and set installer options. ... • Residential or commercial • Non-zoned or zoned • Used with or without an Equipment Interface Module ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: