Transcription of Series with RedLINK Installation Guide
{{id}} {{{paragraph}}}
Example: quiz answers
Series with RedLINK Installation Guide
VisionPRO Series with RedLINK Installation GuideTMTMORORW ired Directly to Equipment2 Wires for Power orBattery Only (no wires)2 Wires for Power orBattery Only (no wires)Dual Powered - C Wire or Battery(C wire or Wire Saver required to use RedLINK accessories) RedLINK to Equipment Interface ModuleRedLINK to TrueZONE Wireless AdapterTM 2 Current display. Underlined label signifies the current control buttons. Use to change settings for Fan or System Select options to: set schedules, view equipment status, change IAQ settings, access installer options*, status. Shows system mode (heat/cool), outdoor temperature and humidity (with optional outdoor sensor).Current schedule. Shows desired temperature and schedule conditions. Shows indoor temperature and Light. On when alert message is active or system is set to Em Heat. Flashes for battery-only power; on continuous for 24 Card Port. Use card to load settings and dealer to key features* Password is the date startedFollow these basic steps to install this thermostat, link it with the wireless accessories, and set installer Installing the thermostat2 Powering optional RedLINK accessories3 Performing initial setup4 Finding your password (Date Code) To add or remove RedLINK accessories To make changes to Installer Setup To perform an Installer TestResidential/R sidentiel1-800-468-1502 , Golden Val
3 NOTE: For best RedLINK performance, mount thermostats at least 2 feet apart. 1.1 Separate wallplate from thermostat. Press button on top and pull to remove the wallplate.
Loading..
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: