Transcription of Sipha Control Units Installation Instructions
{{id}} {{{paragraph}}}
Example: bachelor of science
Sipha Control Units Installation Instructions
Installation InstructionsOriginal InstructionsSipha Control UnitsCatalog Numbers 440N-S32013, 440N-S32021, 440N-S32052 Summary of ChangesThis publication contains new Installation and updated Declaration of Conformity sections on page competent personnel must install the Sipha Control Units in accordance with the following steps and specifications. Adherence to the recommended maintenance Instructions forms part of the DimensionsFigure 1 - Sipha 1 and 2 [mm (in.)]Figure 2 - Sipha 6 [mm (in.)] Sipha SettingsWARNING: Do not defeat, tamper, remove, or bypass this unit. Severe injury to personnel could mm (DIN)99 ( ) ( )82( )75( )35 mm (DIN)120 ( ) ( )73( ) Sipha 1 Sipha 2 IMPORTANTTo energize outputs, at least one input must be closed after delay has mm (DIN)118 ( )90 ( )84( )83 ( )79( )500 mAT110V AC230V AC IP54500 mAT110V AC230V AC secOutputs D13/D14 Delay30 secOnInput MutingOff12345612 34 Sipha 6 Sipha 22 Rockwell Automation Publication 440N-IN001B-EN-P - September 2019 Sipha Control UnitsApplication Wiring DiagramsWhenever the interlocked guard door is open, check that the machine is isolated and Installation and commissioning, the actuator, switch, and switch lid mounting screws must be coated with tamper evident varnish or a similar (AUX)K1 (AUX)24V AC/DCSiphaSensor +Actuator621534 Sipha 1M4 2 A2 X1 X222 141321A131 STOPM omentaryPush ButtonSTARTM omentaryPush ButtonFUSESK2K1K2 (AUX)K1 (AUX)RESETM omentaryPush ButtonK2K1L2L1L3
Momentary STOP Push Button Momentary Push Button FUSES 123 A1 3 A2 + 4 2 -- X1 X2 24 13 14 K1 K2 24V AC/DC 110/230V AC 110/230V AC RESET Momentary Push Button K1 (AUX) K2 (AUX) SIPHA 2 31 32 1 4 3 2 5 6 Sipha Sensor + Actuator M M 1Y 1R 6G 6B 1B 1G 6R 6Y 2Y 2R 5G 5B 2B 2G 5R 5Y 1 4 3 2 5 6 1 4 3 2 1 4 3 2 5 6 Sipha S12 Sensor + Actuator ON OFF ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: