Transcription of SpaceClaim User’s Guide
{{id}} {{{paragraph}}}
A SpaceClaim DocumentSpaceClaim User s GuideVersion 2007 Copyright 2007 SpaceClaim Corporation. All Rights Reserved. SpaceClaim is a registered trademark of SpaceClaim Corporation. Anti-Grain Geometry Version Copyright 2002-2005 Maxim Shemanarev (McSeem). Contains Autodesk RealDWG by Autodesk, Inc., Copyright 1998-2006 Autodesk, Inc. All rights reserved. Autodesk, AutoCAD, and Autodesk Inventor are registered trademarks and RealDWG is a trademark of Autodesk, Inc. CATIA is a registered trademark of Dassault Syst mes. Contains DotNetBar licensed from 2007 Microsoft Office System User Interface is licensed from Microsoft.
Click the Tangent Line tool in the Sketch ribbon group. Then click the outer circle and click again on the rectangle. Create another tangent line the same way. f Click in the Quick Access toolbar to save your design. 4 Pull the bracket sketch into 3D. a Click the Pull tool in the Edit ribbon group. Notice that the sketch is
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}