Transcription of SPECIFICATION FOR SEAMLESS STEEL …
{{id}} {{{paragraph}}}
Example: air traffic controller
SPECIFICATION FOR SEAMLESS STEEL …
SPECIFICATION FOR SEAMLESS STEELTRANSPORTABLE PRESSURERECEPTACLES DOT - 3E (HSE) 1 DOT 3E (HSE) Issue 1 FEBRUARY 2000 HSEH ealth & OF OF RELIEF CYCLING BURST CYLINDERS122 DOT 3E (HSE) Issue 1 FEBRUARY 2000 INSPECTION AND TESTING13 APPENDIX 1 - INSPECTORS REPORT143 DOT 3E (HSE) Issue 1 FEBRUARY SPECIFICATION details the requirements for the material, design, construction and testing ofseamless STEEL transportable pressure receptacles, ie gas cylinders, over kg with an outsidediameter not exceeding mm, a length less than 610 mm and a service pressure of 125 cylinders to this SPECIFICATION shall not be used for the carriage of OF COMPLIANCEThe Approved Verification (Inspection) Body shall certify that the manufacture, inspection andtesting of the cylinders was carried out in compliance with the requirements of this : A suitable form of certificate is shown in Appendix - Compressed Gas Association - Hydrostatic STEELOpen-hearth or electric STEEL of uniform quality.
P = minimum test pressure prescribed for water jacket test in bar D = outside diameter in mm d = inside diameter in mm 9. HEAT TREATMENT 9.1 The completed cylinders must be uniformly and properly heat treated to a procedure
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: