Transcription of Specifying Shell-and-Tube Heat Exchangers
{{id}} {{{paragraph}}}
Specifying Shell-and-Tube Heat Exchangers Understand what heat exchanger design specialists need to know and remember, you know your process best Asif Raza Shell-and-Tube heat Exchangers are one of the most important and commonly used process equipment items in the chemical process industries (CPI). If you are working on a project during either the basic or the detailed engineering phase, there is a good chance that you will need to specify one or more Shell-and-Tube Exchangers and perhaps many of them. While the actual design will likely be done by a specialist at an equipment vendor or within your own company, you still need to fill out a process datasheet for each heat exchanger and in due course, review the vendor s detailed proposal. You know your process best, and it is a bad idea to rely on the vendor always to make the right decisions. This article shows you the basics of Specifying and selecting Shell-and-Tube heat Exchangers : the process information and preliminary design decisions needed to fill out the datasheet, and how to check any corresponding assumptions made by the vendor.
Shell-and-tube heat exchangers are one of the most important and commonly used process equipment items in the chemical process industries (CPI). If you are working on a project during either the basic or the detailed engineering phase, there is a good chance that you will need to specify one or more shell-and-tube exchangers — and perhaps many
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}