Transcription of ST-LINK/V2 in-circuit debugger/programmer for …
{{id}} {{{paragraph}}}
For further information contact your local STMicroelectronics sales 2016 DocID018751 Rev 41/4ST-LINK/V2ST-LINK/V2 in- circuit debugger / programmer for STM8 and STM32 Data briefFeatures 5 V power supplied by a USB connector USB full-speed-compatible interface USB standard A to Mini- B cable SWIM specific features V to V application voltagesupported on SWIM interface SWIM low-speed and high-speed modessupported SWIM programming speed Kbytes/s in low speed Kbytes/s in high speed SWIM cable for connection to theapplication via an ERNI standardvertical connector (ref: 284697 or 214017)or horizontal connector (ref: 214012) SWIM cable for connection to theapplication via a pin header or a mmpitch connector JTAG/serial wire debugging (SWD) specificfeatures: V to V application voltagesupported on the JTAG/SWD interface and5 V tolerant inputs JTAG cable for connection to a standardJTAG 20-pin pitch mm connector JTAG supported SWD and serial wire viewer (SWV)communication supported Direct firmware update feature supported(DFU) Status LED which blinks during communicationwith the PC Operating temperature 0 to 50 C 1000 Vrms high isolation voltage( ST-LINK/V2 -ISOL only) first figure at the top shows the ST-LINK/V2 -ISOL, while the second figure shows the ST- Rev 4 DescriptionThe ST-LINK/V2 is an in- circuit debu
Description ST-LINK/V2 2/4 DocID018751 Rev 4 Description The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}