Transcription of Stepper motor controllers - STMicroelectronics
{{id}} {{{paragraph}}}
L297 Stepper motor CONTROLLERSNORMAL/WAVE DRIVEHALF/FULL STEP MODESCLOCKWISE/ANTICLOCKWISE DIRECTIONSWITCHMODE LOAD CURRENT REGULA-TIONPROGRAMMABLE LOAD CURRENTFEW EXTERNAL COMPONENTSRESET INPUT & HOME OUTPUTENABLE INPUTDESCRIPTIONThe L297 Stepper motor Controller IC generatesfour phase drive signals for two phase bipolar andfour phase unipolar step motors in microcomputer-controlled applications. The motor can be driven inhalf step, normal and wawe drive modes and on-chip PWM chopper circuits permit switch-modecontrol of the current in the windings. A feature ofDecember 2001 SymbolParameterValueUnitVsSupply voltage10 VViInput signals7 VPtotTotal power dissipation (Tamb = 70 C)1 WTstg, TjStorage and junction temperature-40 to + 150 CABSOLUTE MAXIMUM RATINGS this device is that it requires only clock, directionand mode input signals. Since the phase are gen-erated internally the burden on the microprocessor,and the programmer, is greatly reduced.
even-numbered state. ... Ground noise problems in multiple configurations can be avoided by synchronising the chopper os-cillators. This is done by connecting all the SYNC ... when the translator is at an odd numbered state (1, 3, 5 or 7). In this mode the INH1 and INH2 outputs remain high throughout. 5/11 L297.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}