Transcription of STRUCTURAL MODELING NOTES PART 1 - USING ETABS
{{id}} {{{paragraph}}}
Example: confidence
STRUCTURAL MODELING NOTES PART 1 - USING ETABS
STRUCTURAL MODELING NOTES Date: JULY 2019 Rev.: Prepared by: Dr. Mahmoud El-Kateb P a g e | 1 STRUCTURAL MODELING NOTES PART 1 - USING ETABS STRUCTURAL MODELING NOTES Date: JULY 2019 Rev.: Prepared by: Dr. Mahmoud El-Kateb P a g e | 2 TABLE OF CONTENTS 1. INTRODUCTION .. 5 2. DEFINE MATERIAL PROPERTIES .. 5 3. DEFINE SECTION PROPERTIES .. 7 4. DEFINE DIAPHRAGMS .. 9 5. DEFINE RESPONSE SPECTRUM FUNCTION .. 10 6. DEFINE MASS SOURCE .. 13 7. DEFINE P-DELTA OPTIONS .. 14 8. DEFINE MODAL CASES .. 15 9. DEFINE LOAD PATTERNS .. 16 10. DEFINE LOAD CASES .. 22 11. DEFINE LOAD COMBINATIONS .. 23 12. DEFINE AUTO CONSTRUCTION SEQUENCE CASE .. 23 13.
STRUCTURAL MODELING NOTES Date: JULY 2019 Rev.: 3.5 Prepared by: Dr. Mahmoud El-Kateb P a g e | 5 1. INTRODUCTION The main objective of this manual is to set a guideline to be followed by structural design team during phases of structural modeling using CSI software (ETABS), and structural analysis.
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: