Transcription of STRUCTURAL MODELING NOTES PART 1 - USING ETABS
{{id}} {{{paragraph}}}
Example: bankruptcy
STRUCTURAL MODELING NOTES PART 1 - USING ETABS
STRUCTURAL MODELING NOTES Date: JULY 2019 Rev.: Prepared by: Dr. Mahmoud El-Kateb P a g e | 1 STRUCTURAL MODELING NOTES PART 1 - USING ETABS STRUCTURAL MODELING NOTES Date: JULY 2019 Rev.: Prepared by: Dr. Mahmoud El-Kateb P a g e | 2 TABLE OF CONTENTS 1. INTRODUCTION .. 5 2. DEFINE MATERIAL PROPERTIES .. 5 3. DEFINE SECTION PROPERTIES .. 7 4. DEFINE DIAPHRAGMS .. 9 5. DEFINE RESPONSE SPECTRUM FUNCTION .. 10 6. DEFINE MASS SOURCE .. 13 7. DEFINE P-DELTA OPTIONS .. 14 8. DEFINE MODAL CASES .. 15 9. DEFINE LOAD PATTERNS .. 16 10. DEFINE LOAD CASES .. 22 11. DEFINE LOAD COMBINATIONS.
phases of structural modeling using CSI software (ETABS), and structural analysis. This manual contains parameters, procedures and recommendations concern mostly about reinforced concrete structures and that comply with the CSI manuals and technical papers as well as the common design codes as listed hereafter;
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: