Swimming Pool A4-folder - Pool Rock

Using a three way valve, connect a 25mm (1/2 ). 1. flexible hose from the pool pump to the waterfall outlet. Dig hose under ground if water flow. Place Waterfall & Edge Rocks in 2. desired position. 3 Way Valve 3. 4. 5. To ensure a tight fit on you pool, Cut off excess rock with a sharp Replace rock, then scribe with a mark shape of coping edge onto the knife. Do this gradually to ensure a pencil or chalk the outer edges onto rocks. professional finish. the coping. 6. 7. 8. Using suitable sized blocks of wood, After determining blocks position, Pre-drill holes into timber blocks &. lift rock & position blocks under & remove rock & outline in preparation pool coping for insertion of bolts. against internal rock edges. for fastening. 2-4 blocks per item may be needed. 9. 10. 11. Using stainless steel bolts, hammer Place rocks back over blocks & mark Screw through rock into block. through block into coping ensuring a on pool edge to help guide where to Stainless steel screws are advised to pre- structural installation.

Place Waterfall & Edge Rocks in desired position. To ensure a tight fit on you pool, mark shape of coping edge onto the rocks. Using suitable sized blocks of wood,

Loading..

Tags:

  Loops

Information

Related search queries