Transcription of SZ16-ZN/EN-A05 Adventurer 3 User Guide - Flashforge
{{id}} {{{paragraph}}}
Example: biology
SZ16-ZN/EN-A05 Adventurer 3 User Guide - Flashforge
SZ16-ZN/EN-A05 . Adventurer 3. User Guide This Guide is only applicable to Flashforge Adventurer3 3D printer Content Preface Notice Terms Chapter 1: About Adventurer 3 06. - Components Introduce 06. - Reference 07. Chapter 2: Operating 08. - Unpacking 08. - Accessories 10. - Interface 11. - Build 11. - Tools 13. - NetWork 13. - Preheat 16. - Setting 19. - About 20. - Filament 21. - Print 22. - Load Filament 22. - Model File Transfer 24. - Print 29. - FlashCloud Print 29. - PolarCloud Print 31. - Model Remove 35. - Replace Filament 36. - The Guide of Using Camera 37. - The Switching Can Be Controlled by the Lower Computer 37. - FlashCloud Camera Use 38. - PolarCloud Camera Use 40. - The Switching Can Be Controlled Through the Cloud 42. - Error Handling 44. Chapter 3: Q&A 37. Chapter 4: Supports and Service 40. 01. Preface Note: Each device must be tested before leaving factory. If there are some residues in extruder or some tiny scratches on the build tape, it is normal and won't affect the printing quality.
documents and control the printer. 04 Environment Requirements Place Requirements Filament Requirements Filament Storage Legal Notice The device must be placed in a dry and ventilated environment. The distances of the left, right and back side space should be at least 20cm, and the distance of the front side space should be at least 35cm ...
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: