Transcription of TANK DESIGN & DETAILING Introduction - PVtools
{{id}} {{{paragraph}}}
TANK DESIGN & DETAILINGI ntroductionThe API 650 standard is designed to provide the petroleum industry with tanks of adequate safety and reasonableeconomy for use in the storage of petroleum, petroleum products, and other liquid products commonly handled andstored by the various branches of the industry. This standard does not present or establish a fixed series ofallowable tank sizes; instead, it is intended to permit the purchaser to select whatever size tank may best meet hisneeds. This standard is intended to help purchasers and manufacturers in ordering, fabricating, and erecting tanks ; itis not intended to prohibit purchasers and manufacturers from purchasing or fabricating tanks that meetspecifications other than those contained in this standard has requirements given in two alternate systems of units.
3. plate to plate welding detail 4. three plate welding detail 5. Bottom plate to Annular plate and Back strip welding detail 6. Section Views for plate to plate welding details 7. Bill of materials 8. General Notes DESIGN OF BOTTOM PLATE: (CL 3.4.1 of API-650) and BS 2654 Bottom plate thickness = 6mm + C.A Min plate thickness for Stainless ...
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}