Scaffold, Ladder and Fall Protection Program - ehs.umich.edu

Glossary of Terms . TERM DEFINITION . Aerial Lift A mobile device used to elevate workers to job sites above the ground. It includes extension boom platforms, aerial ladders, ... Scaffolding The process of building or taking down a scaffold to or from its completed state. Fabricated Frame Scaffold

  Terms, Glossary, Glossary of terms, Scaffolding

CONSTRUCTION SAFETY REQUIREMENTS

Subcontractor/Trade Contractor: Where “subcontractor/trade contractors” is ... a comprehensive health and safety program appropriate for the Work or services performed that ... subcontractors/trade contractors engaged on a project per their own written prequalification process. U-M Construction Safety Requirements of 32 January 2010 (Rev. 1 ...

  Health, Requirements, Safety, Construction, Prequalifications, Subcontractor, Health and safety, Construction safety requirements

Laboratory Hoods – What’s the Difference?

Biosafety Cabinet Chemical Fume Hood Animal Transfer Station Primarily designed to provide a sterile work environment. Does not provide any protection to personnel or environment. Primarily designed to protect against exposure to particulates and aerosols from biological agents. Provides product, personnel and environmental protection.

  Chemical, Environment

Specific Procedures for Use of Self-Contained Breathing ...

is IDLH, the following procedures will be followed: • Contact Department of Public Safety and Security (DPSS) at 9-1-1 (with a campus phone) and inform them of the exact nature of the emergency and need for SCBA use. Also, report the number of SCBA units, breathing air cylinders on hand, and the number of authorized users on hand;

  Procedures

University of Michigan COVID-19 Vaccination Policy Updated ...

This policy is subject to change as the pandemic and public health guidance continue to evolve and will be regularly reviewed as public health guidance dictates. Scope This policy applies to all faculty, staff, and students, including temporary employees, on the U-M Ann Arbor, Michigan Medicine, Dearborn, and Flint campuses.

  Public, Employee, Michigan

Monthly Safety Report - University of Michigan

Electrical (e.g., overhead power lines, power tools/cords, outlets, wiring) Overexertion Inhalation Heat Other (other items not covered above) EMPLOYMENT INFORMATION (includes contract workers) Average Daily Number of Employees (FTE’s) Total Hours Worked by Employees . PROJECT SAFETY ACTIVITIES. Safety Orientations Completed

  Report, Safety, Power, Line, Monthly, Overhead, Monthly safety report, Overhead power lines

NCRP Recommendations for Ending Routine Gonadal …

This corresponded to estimated gonadal doses for unshielded patients of 10 to 11 mGy and 4 mGy for adult males and females, respectively (Somasundaram et al. 2020). Three developments since the 1950s have ... SPR is low near the surface of the body where the x-ray beam enters (e.g., at the expected location of the tes-tes), intermediate at the ...

  Surfaces, Recommendations, Routines, Ending, Nrcp, Unshielded, Gonadal, Ncrp recommendations for ending routine gonadal

Laboratory Ultraviolet Light Sources - Princeton University

UV levels in the actinic region for unshielded transilluminators. In conclusion, the authors stated: ... to shield the exposed surface of the transilluminator. No UV is detectable with the shield in place. A measurement with a UV radiometer indicated an exposure level of 200 µW/cm: 2

  Surfaces, Unshielded

H-MTD® High-Speed Modular Twisted-Pair Data Products

including Shielded Twisted Pair, Unshielded Twisted Pair and new High-Performance cables. ... 0M Surface mount device xx Blank cable group: 1 Crimp 4 PCB mounting: Successive number 1 Straight connector: 2 Right angle connector K Female jack: S Male plug W Tools: Z Plastic housings and accessories

  Surfaces, Unshielded

Heat Dissipation in Electrical Enclosures | Fan/Blower …

Enclosure Surface Area The physical size of the enclosure is the primary factor in determining its ability to dissipate heat. The larger the surface area of the enclosure, the lower the temperature rise due to the heat generated within it. To determine the surface area of an enclosure in square feet, use the following equation:

  Surfaces, Electrical, Heat, Enclosure, Dissipation, Heat dissipation in electrical enclosures

Technical Explanation for Proximity Sensors - Omron

The distance from the reference position (reference surface) to the measured operation (rese t) when the standard sensing object is moved by the specified method. Set Distance The distance from the reference surface that allows stable use, including the effects of temperature and voltage, to the (standard) sensing object transit position. This is

  Surfaces, Proximity

D-SUB CONNECTORS - Amphenol

Surface mount • Five shell sizes offer widest choice of contact positions: 9, 15, 25, 37 and 50 in standard density and 15, 26, 44, 62 and 78 positions in high-density. • Inserts are flame-retardant thermoplastic. • Accessories for all applications are available including strain reliefs, cable clamps, shielded backshells, mating hardware

  Surfaces, Connectors

Cytation™ 5 - University of Wisconsin–Madison

Operate the instrument on a level, stable surface away from excessive humidity. Bright sunlight or strong incandescent light can reduce the linear performance range of the instrument. Measurement values may be affected by extraneous particles (such as dust) in the microplate wells. A clean work area is necessary to ensure accurate readings.

  Surfaces, Cytation

Chapter 5 External Dose Calculations H-117 – Introductory …

Review ¾List the three methods of reducing your exposure/dose: ¾Intensity decreases _____ with the square of the distance from the source due only to the change in _____. H-117 – Introductory Health Physics Slide 31 ¾Using the inverse square law, calculate the dose rate at 4 feet away from a point source if the dose rate is originally 1000 R/hr at 2 feet.