Technical Data Pressure Ratings, General Reference

Technical Data Pressure Ratings, General Reference Hydraulic Tube Fittings, Pressure Ratings lowest Pressure rated fitting end. For example, a fitting The information contained in this catalog is subject to may include one -4 (1/4") male 37 degree tube end and change without notice. The most current information can one -6 (3/8") male pipe end. From the tables below, the be found on the Air-Way web site rated working Pressure for the -4 male 37 degree tube The hydraulic tube fittings represented in this catalog end is MPa (5,000 psi) and the rated working conform to the performance requirements specified in Pressure of the -6 (3/8") male pipe end is 21 MPa (3,000. SAE J514, SAE J518, SAE J1453, SAE J1926/ISO psi). The rated working Pressure of the fitting would be 11926 and related standards . 21 MPa (3,000 psi). The working Pressure ratings listed below are based on For proper performance, the design of any hydraulic a 4:1 design factor for minimum burst. As specified in system should take into consideration the rated working SAE J514, these are dynamic Pressure ratings and the pressures for each of the components of the system, fittings are capable of passing a cyclic endurance including standard ratings for hose and tubing (impulse) test for one million cycles at 133% of the components and assemblies.

Straight Thread Stud Ends (Inch) Nominal Tube Size Thread Size (Notes 1&2) Working Pressures Nom SAE Dash Size Nom Inch ... American Standard Straight Pipe Thread for Mechanical Joints . ... -5 5/85/16 -18 UNF 1/2 20 UNF 41.3 6,00063 6,000 40

Loading..

Tags:

  Standards, Thread, Inch

Information

Related search queries