PDF4PRO ⚡AMP

Modern search engine that looking for books and documents around the web

Example: confidence

Technical Guide: Area Separation Walls (DensGlass® Shaftliner)

TECHNICAL GUIDE SHAFTLINER FOR AREA SEPARATION WALLS. ... (Intertek/WHI fire test) or a total height of up to 44’ (13,411 mm) with a UL assembly. Because it is constructed using gypsum board, the assembly is easy to erect, secure and provides economical fire protection and sound control. DensGlass Shaftliner conforms to the requirements of ...

Fullscreen Download

Tags:

  Guide, Intertek

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Spam in document Broken preview Other abuse

Documents from same domain

TECHNICAL GUIDE - Georgia-Pacific Building Products

www.buildgp.com

installation. DensGlass Sheathing is the ideal substrate for a wide variety of air and water-resistive barriers including building wraps, fluid applied coatings, self-adhering membranes and spray foam applications. See page 10 for details. Easy to Handle DensGlass Sheathing is lightweight and easy to handle.

  Guide, Product, Technical, Pacific, Building, Georgia, Wrap, Technical guide, Building wraps, Georgia pacific building products

SHAFTLINER FOR SHAFTWALL/STAIRWELL SYSTEMS

www.buildgp.com

Note that the edges of the panel are beveled to help guide the panel into the slotted and tabbed section of the stud. 6. Progressively install succeeding studs and panels as described above until the wall section is enclosed. The final panel section may be secured with 1-5/8” (41 mm) Type S screws or tabs from the J track at 24” (610 mm) o ...

  Panels

TECHNICAL GUIDE - Gypsum, Wood, Lumber, OSB Boards

www.buildgp.com

Dec 01, 2017 · The unique construction has been shown to withstand delamination, deterioration, warping and job site damage far more effectively than paper-faced gypsum board and other conventional roofing products such as wood fiberboard and perlite. • Provides superior fire protection. • Resists fire and hail damage.

  Guide, Construction, Gypsum

Technical Guide: DensArmor Plus® High-Performance Interior ...

www.buildgp.com

of Gypsum Panel Products” and ASTM C840 “Standard Specifi cation for Application and Finishing of Gypsum Board for Non-Fire Rated Construction.” For best results, abut DensArmor Plus panels against regular paper-faced drywall only at inside or outside

  Guide, Construction, Gypsum

Technical Service Hotline 1.800.225.6119 or www.gpgypsum

www.buildgp.com

assembly installation instructions). Primary Uses Because of the superior performance of DensGlass Sheathing, it is specified for exterior walls, ceilings and soffits in a wide variety of applications. These include exterior insulation and finish systems (EIFS); cavity brick or stone veneer applications;

  Services, Installation, Technical, Instructions, Installation instructions, 1961, Hotline, Technical service hotline 1, 6119 or

Stamps/Signatures

www.buildgp.com

FIRE SAFETY CAUTION Passing a fire test in a controlled laboratory setting and/or certifying or labeling a product as having a one-hour, two-hour, or any other fire resistance or protection rating and, therefore, as acceptable for use in certain …

  Protection, Fire

DensShield® Tile Backer Installation Instructions

www.buildgp.com

DS001. Note: Shower pan or rubber membrane must be adequately sloped to the open drain or weep hole detail to permit proper water drainage. Leave a 1⁄89 (3 mm) gap between DensShield Tile Backer and the shower pan. • DensShield Tile Backer is not to be used in shower curbs. • DensShield Tile Backer panels can be installed in the shower

  Sd100

Technical Service Hotline 1.800.225.6119 or www.densdeck

www.buildgp.com

manufacturer’s specifications for full mopping applications and temperature requirements. ... * Testing was done in accordance with FM approvals 4470, Appendix C: Small Scale Tests, Membrane ... with the ANSI/UL 1256 Steiner Tunnel test. For additional information concerning

  Tests, Scale, Tunnel, Full, Cast steel

Related documents

Guide to Equipment Certification Requirements - Intertek

www.intertek.com

HZL 0314 NORTH AMERICA ATEX & IECEx Contact Intertek with questions about Hazardous Locations & Explosive Atmospheres testing and certi˜cation icenter@intertek.com 1 ...

  Guide, Intertek

Guide to Electrical Safety Testing - Hipot

go.hipot.com

(CSA - Canada), ETL (Intertek - United States) and CCC (China Compulsory Certification - China) Electrical products can be classified according to insulation type Class I Products • Terminate in 3 prong line cord (line, neutral and ground). • Ground prong connects to product chassis. • Safety through basic insulation and proper grounding.

  Guide, Intertek

GreenGuard XPS Insulation Board Installation Guide

www.generalinsulation.com

practice. This information is intended to be used as a guide. For information regarding other applications and more detailed product information go to www.kingspaninsulation.us. Alternate installation details may be used if approved in writing by Kingspan Insulation LLC prior to installation. Personal Protective Equipment

  Guide

Related search queries

Guide, Intertek