Transcription of Technical information on plastics - Radel
{{id}} {{{paragraph}}}
Example: confidence
Technical information on plastics - Radel
646* Standard products are subject to the tolerances underDIN 16901. In the case of special materials, the nominaldimensions change in accordance with the oscillationdifference from the special material, as do the tolerancegroups.* Deviations in dimensions and shapes from the standardversions are due to differences in shrinkage and shrink-age behaviour.* Deviations in colour from standard or RAL colour chartsoccur.* In other surface properties, such as- gloss- structures- lines of flow or streaks on dark colours* Stronger ridges may form* Colour additives can affect the material properties(combustibility, UV resistance)* or advice for machining plastic enclosuresMilling, drillingWhen machining plastic enclosures, the tools must only becooled with oil-free air. Drilling coolants and separatorscan cause splitting and tearing. When using separatorscontaining silicone, subsequent imprinting and lacqueringis not possible as the lacquer would not adhere case of doubt please ask us for machining service protects you against these plastic parts are punched, corners can tear or quality of a glued joint depends on the materials to beglued, the size of the glued area, and the adhesive following should be taken into consideration:1) Only glue the same materials 2) Glue as large an area as possible3) Use suitable glues and follow the Technical ins
646 * Standard products are subject to the tolerances under DIN 16901. In the case of special materials, the nominal dimensions change in accordance with the oscillation
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: