Transcription of TH5110D Non-programmable Thermostat
{{id}} {{{paragraph}}}
Example: tourism industry
TH5110D Non-programmable Thermostat
TH5110D Non-programmable Thermostat INSTALLATION INSTRUCTIONS. APPLICATION. cooling systems or 750 mV heating systems. See Table 1. The TH5110D Non-programmable Thermostat provides for a description. electronic control of 24 Vac, single-stage heating and Table 1. TH5110D Thermostat description. Feature Description Powering Methods Battery only Common wire only Common wire with battery backup System Types (Up to 1 Heat, 1 Cool) Gas, oil or electric heat with air conditioning Warm air, hot water, high efficiency furnaces, heat pumps, steam and gravity Heat only includes power to open and power to close zone valves (Series 20) and normally-open zone valves Heat only with fan Cool only 750 mV heating systems Changeover Manual or auto changeover selectable System Setting Heat-Off-Cool-Auto Fan Setting Auto-On MERCURY NOTICE. If this control is replacing a control that contains mercury in a sealed tube, do not place your old control in the trash.
application. Insert the wires into the terminal block and tighten each screw terminal. See Fig. 4. Fig. 4. Insert wires into terminal block. 2. Push excess wire back into the wall opening and restrict wires to the shaded area. See Fig. 5. Fig. 5. Restrict wires to shaded area of wire hole. 3. Plug the wall opening with nonflammable insulation
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: