Transcription of The Atmel-ICE Debugger - Microchip Technology
{{id}} {{{paragraph}}}
Example: marketing
The Atmel-ICE Debugger - Microchip Technology
Programmers and Debuggers Atmel-ICE USER GUIDEThe Atmel-ICE DebuggerAtmel-ICE is a powerful development tool for debugging and programmingARM Cortex -M based Atmel SAM and Atmel AVR microcontrollers withOn-Chip Debug supports: Programming and on-chip debugging of all Atmel AVR 32-bitmicrocontrollers on both JTAG and aWire interfaces Programming and on-chip debugging of all Atmel AVR XMEGA familydevices on both JTAG and PDI 2-wire interfaces Programming (JTAG, SPI, UPDI) and debugging of all Atmel AVR 8-bitmicrocontrollers with OCD support on either JTAG, debugWIRE orUPDI interfaces Programming and debugging of all Atmel SAM ARM Cortex-M basedmicrocontrollers on both SWD and JTAG interfaces Programming (TPI) of all Atmel tinyAVR 8-bit microcontrollers withsupport for this interfaceConsult the supported devices list in the Atmel Studio User Guide for a fulllist of devices and interfaces supported by this firmware Guide-10/2016 Table of ContentsThe Atmel-ICE to the Started with the Kit Kit Kit Parts the the the to the Host Driver the to AVR and SAM Target to a JTAG to an aWire to a PDI to a UPDI to a debugWIRE to an SPI to a TPI to an SWD to Data Gateway Devices with CoreSight Physical to a JTAG Physical to an SWD UC3 Devices with AVR UC3 On-chip Debug Physical to a JTAG Atmel-ICE [USER GUIDE]Atmel-42330C-Atmel.
To assemble your Atmel-ICE into its default configuration, connect the 10-pin 50-mil IDC cable to the unit as shown below. Be sure to orient the cable so that the red wire (pin 1) on the cable aligns with the triangular indicator on the blue belt of the enclosure. The cable should connect upwards from the unit. Be
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: