Transcription of The Basics of Tube & Pipe Bending
{{id}} {{{paragraph}}}
The Basics of Tube & Pipe Bending Tracto-Technik GmbH Spezialmaschinen Plant II y Rohrumformtechnik Hunold-Rump-Stra e 76-80 D-57368 Lennestadt Tel.: +49 (0) 27 25 / 95 40-0 Fax: +49 (0) 27 25 / 95 40-33 E-mail: Website: The Basics of Tube & Pipe Bending Tracto-Technik GmbH, Plant II - 2 - by Michael Rohrmann January 2005. Tracto-Technik GmbH, D-57368 Lennestadt The Basics of Tube & Pipe Bending Tracto-Technik GmbH, Plant II - 3 - C O N T E N T S 1. Reshaping by Bending .
means of hydraulics. This motion forces the pipe inserted between the radius block and the counter-rollers to bend around the radius. The pipe cannot be supported from within, therefore this method is suitable for thick-walled pipes and large bending radii only. Also 3-roll-bending is used for producing work pieces with large bending radii.
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
{{id}} {{{paragraph}}}