Transcription of Tightening Torques - MWRENCH
{{id}} {{{paragraph}}}
Example: barber
Tightening Torques - MWRENCH
Tightening Torques 20/10/97. 00 - 1 General Instructions Type Screw Dimensio Unit n 00 00 Extract from company standard BMW N 600 The maximum Tightening Torques are: Only applicable to shaft screws with metric standard and fine threads acc. to DIN 13, sheet 13 and nuts with height of 0,8 x d acc. to DIN 934 and only for a . total = (screws phosphatized, screws untreated or galvanized. Lubrication condition: unlubricated and also oiled). For cadmium-plated screws or nuts ( total = to ) the Tightening torque with screw material at the same level of utilization ca. must be 30% less than shown in the table. The values specified in this table apply to all screw connections conforming to the aforementioned conditions. Not applicable when using a different surface or lubricant condition on the thread, or if the height of the nut differs.
1 AZD00-01.frb 20/10/97 00 - General Instructions Type Screw Dimensio n Unit 00 00 Extract from company standard BMW N 600 02.0 The maximum tightening torques are: Only applicable to shaft screws with metric standard and fine threads acc. to
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: