Transcription of Tire Manufacturing Processes
{{id}} {{{paragraph}}}
Example: biology
Tire Manufacturing Processes
Tire ManufacturingProcessesFor more information about tire defects, blowouts andtread separations contact the law offices of Kaster &Lynch, at (352) BELTED RADIAL PASSENGER AND LIGHT TRUCK TIRESMost steel belted radial passenger and light truck tires are composedof an inner liner, two polyester reinforced body plies, two steel beads, twobead reinforcing strips, two anti-chafing strips, two steel belts, with belt edgewedges or wrap around gum strips, the sidewalls, and the tread. Many tiresalso include one or two layers of nylon or polyester constricting belts or stripsover the steel belts (safety belts or cap plies). See pictorial, Exhibit most common failure mode of steel belted radial passenger andlight truck tires is separation between the steel belt components. This areais subject to the highest amount of stress during normal use and is also thearea of weakest potential adhesion because of the difficulty of bonding rubberto metal and the mechanical stress at the belt edges.
adhesion. Both the polyester cords and steel cords are cut at specified angles and widths for use in tire building. III. EXTRUSION Some tire components are formed by extrusion of uncured rubber, including tread and sidewall components. Extruders are both hot and cold fed
Loading..
Tags:
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: