Section 5: Track Geometry - Extranet

Authorised users of this document should visit ARTC’s intranet or extranet (www.artc.com.au) to access the latest version of this document. CONFIDENTIAL Page 1 of 31 . Track Geometry . Section 5 . Applicability . ARTC Network Wide

  Extranet

Earthworks, Formation and Capping Material - Engineering

Engineering (Track & Civil) Standard ETM-08-01 Earthworks, Formation and Capping Material Contents Version 1.1 Date of last revision: 18 Jun 10 Page 3 of 17

  Material, Formation, Capping, Earthwork, Formation and capping material

Construction of Cable Route and Associated Civil Works

Engineering (Signalling) Standard ESC-11-01 Construction of Cable Route and Associated Civil Works General 1 General 1.1 Scope This document describes the requirements for …

EGP-04-01 - Engineering Drawings and Documentation

CAD Computer Aided Design CAD Drawing Reference Native format CAD drawing files containing surveying products or design objects which are loaded into native CAD drawing sheets (commonly known as Xrefs). ... • ESD-25-01 CAD and Drafting Manual for Signalling Drawings

  Computer, Design, Drafting, Aided, Cad computer aided design cad

Engineering, Design and Project Management ... - Extranet

Authorised users of this document should visit ARTC’s intranet or extranet (www.artc.com.au) to access the latest version of this document. CONFIDENTIAL Page 1 of 21 Engineering, Design and Project Management Identification of Competence Procedure EGP-01-03 Applicability ARTC Network Wide Publication Requirement Internal / External

  Extranet

Section 1: Rail - Australian Rail Track Corporation

Rail Section 1 Section 1: Rail This document is uncontrolled when printed. Version Number: 5.0 Date Reviewed: 15 Jun 21 Page 6 of 73 1.2.2.1 Use of modified profile 60kg rail sections – Tangent tracks 60 kg/m rail can be sourced in two head profile forms to …

  Rail

Operational failure modes of Switches and Crossings

TURNOUT COMPONENTS / SYSTEM ... contact geometry can be found in a number of defects and simulation tools have been proved very efficient to take this into account. Optimization work in this area therefore has the potential to improve several types of defects modes. D13.1 – …

  Dome, Operational, Failure, Geometry, Switches, Turnouts, Operational failure modes of switches

TRACKWORK doing it right - Scenic Express

angle is a matter of geometry. It is an important consideration in the design of trackwork and ideally should not be less than the minimum radius your rolling stock will easily take. • Lead is the length from the point of the frog to the point-end of the switch point rails (Figure 4). • NMRA dimensions. The data in the table below are for

  Geometry